Features and Benefits Each and every club that we build is done as if it were one of out own. We do not operate a high output assembly line. Each set is custom crafted, built as a matching set, to our customer's requirements. Custom Built to Golfer's Requirements | Made to required flex, length, grip etc | Clubs manufactured to highest standards | All Custom Sets are Frequency Matched through out set. Each shaft is Spined, F.L.O. tested and assembled to give the best possible performance. | Only top quality components used. | Brand names such as SMT GOLF, Raven Golf and Vulcan Golf components are used. | Warranty | One Year Parts and Labor repair / replacement warranty or manufacturers warranty, which ever is longer. | Optional Build Methods | With our advanced equipment, we can build your set Standard, MOI, TTL | | |
All of our assembled clubs are "Spine Aligned" Here's why.. Every golf club shaft is as unique as a fingerprint. In fact, because of the vagaries of the various manufacturing stages (for both steel and composite shafts), it is virtually impossible for any manufacturer today to achieve a perfectly symmetrical shaft. Consequently, every shaft has a spine, or seam, that runs the entire length of it. And because shafts are installed into clubheads randomly, most sets of clubs have shafts with spine positions that vary from club to club. Shaft spines have been defined in a number of ways...they have been called irregularities; high or low spots; out of round places...the list goes on and on. A good working definition of a spine would concern the position of the shaft in a club that allows the shaft to bend naturally as it was designed to do. Shafts installed with their spines in the neutral position (parallel to the target) permit a club to perform consistently through the set; this is evidenced by player feedback! A best-fit shaft for a player will load and unload in a straight line in relation to the intended target. Spine Aligning helps to ensure that this will occur; shafts that are not spine aligned tend to bend either more toe-up or toe-down than will provide the best shaft plane for the golfer. Independent tests conducted by Golf Science Consultants have shown that in a small population of golfers tested, they have experienced a 20-60% improvement in their percentages of on-centre hits when using clubs that have properly fitted shafts that have been spine aligned. 
For more Details Click Logo True Length Technology™ is a Registered Trademark of Dan’s Custom Golf Shop | 
